How to install vertical blinds easily and effectively

Update:26-12-2020
Summary:

If you want to improve the interior decoration of the h […]

If you want to improve the interior decoration of the house and want to maintain a pleasant atmosphere in the house, it is recommended that you seek the help of a professional blind installation service provider as soon as possible. This article will focus on some basic tips that you should follow to install these items in the best way.
The first step is to determine whether you want to install the vertical blinds inside the windows or hang them outside the windows. If they are installed inside windows, they may improve the appearance and appearance of the house; if they are installed outside windows, they may block sunlight in the best way. The important thing is that you must have the necessary fixing clips and screws to fix these items in the correct position.
The next step is to measure the total length of space from the floor to the top of the window. After completing this task, the next step that should be performed is to increase this measurement type by a quarter of an inch. You should mark the exact location where you want to place the top of the screw. Then, you should place a mounting bracket at least three or four inches from the end of the rail at the top of the wall. You should set up additional brackets so that they are equally spaced between the armrests, and you should also tighten the screws in the best possible way.
The next step is to find out the specific side where the control chain and the transverse wires are to be installed. You should then hold the top rail in the middle of the mounting clips and insert its front lip into the groove on the front of these clips. You should turn to the back of the upper rail until it effectively adheres to the back of the clip.
Later, you should open these items so that the blade supports are kept at an equal distance from each other. Then, the chain should be turned down until the openings of the rods face each other, and the blades should be broken so that the curves face each other in the best way.
The next step is to attach the tension pulley to the bottom of the skirting line and pass the loop of the vertical rope through the top of this type of pulley. You should drag the tension rope until the pulley is tight enough and pull a little on the string. You should mark the power cord with the help of a pencil and release the power cord from this type of pulley. After loosening the power cord, the next step should be to pull it again and tie a knot to a specific position. You should put the ring in this type of pulley and then open and close the vertical blinds in the best way.

0
Views: 335