There are two ways to install curtains: Top installatio […]
There are two ways to install curtains:
Top installation-directly install the curtain track on the roof, and the curtain track is installed on the outside of the plaster line, so the plaster line will be covered without affecting the appearance.
Side installation-install the curtain track about 15 cm above the window to prevent light leakage.
The accuracy of the line drawing and positioning is related to the success or failure of the curtain installation. First, measure the fixed hole distance and the size of the required installation track.
Install curtain rails
(1) The curtain track can be divided into single, double or triple track. When the window width is greater than 1200mm, the curtain rail should be disconnected, the simmering bend should be staggered at the disconnection, the simmering bend should be a gentle curve, and the overlap length should not be less than 200mm. Bright curtain boxes are generally installed with rails first. Machine screws should be added to the heavy curtain rail; the dark curtain box should be installed behind the rail. The small corners of the heavy curtain track should be densely spaced, and the wood screw specification should not be less than 30mm.
(2) Install the hoisting clamp, rotate the clamp 90 degrees to connect with the track, and install the hoisting clamp on the top plate with self-tapping screws. If it is a concrete structure, it is necessary to add expanded screws.
Install curtain rods
(1) Correct the connection fixing part, install the rod or iron wire, and pull it on the fixing part. Make it level and straight with the same elevation as the room.
(2) Install standard curtain rails (dual rails), and its foundation width should generally be more than 15cm, and the single rail can be reduced according to appropriate conditions.
Adjust position
For floor-to-ceiling curtains or curtains that hang over the countertop, the width of the window sill should be allowed when installing the rails to prevent the curtains from being obstructed and unsightly when they sag.
Pay attention to the solid wall
It must not be hollow, otherwise the veneer will burst easily when drilling.
